copy of Prym Bias tape maker blue 25mm
CHF24.90
Tax Included
price CHF24.90
price CHF24.90 (tax excl.)
price CHF24.90 (tax incl.)
This battery-operated lint shaver makes woolen clothing look like new in no time. A scissor insert with sharp blades rotates behind the perforated shaving head. When lightly pressed over the fabric, it shaves off protruding lint and small pills and collects them in its collection container. Depending on the material, the distance can be quickly and easily adjusted to two levels. The device can be easily disassembled for cleaning and cleaned with the included brush. Batteries (2 x AA / 1.5 V) are not included.
With our bias tape maker you can easily make your own bias tape. So you always have the right ribbon for your sewing project. The respective width is embossed on the bias tape formers: 12mm, 18mm, 25mm or 50mm. The specification refers to the width of the finished (folded) bias binding. Bias tape is not cut in a straight line, but diagonally. This makes the band slightly stretchy, e.g. to be able to lay curves.
Details
- Width (finished bias binding): 25 mm
And this is how it works
- Fold the fabric at a 45° angle, secure the edge with a couple of pins and then cut the edge.
- You now have 2 pieces of fabric with a 45° edge. If you now put the lower right piece on top of the other one, you get a parallelogram.
- To connect the two pieces of fabric together, fold the top piece down onto the bottom piece, right sides together, and stitch along the overlapping edge with a 1cm seam allowance. Then iron open the seam allowances on the back.
- Then turn the parallelogram right side up and use a pencil to mark the width of your fabric strips. The strips now have to be cut twice as wide as you want your finished bias binding to be. For a 12mm wide bias tape the strips of fabric must be 24mm wide, for a 18mm wide tape 36mm, for a 25mm wide tape 50mm and for a 50mm wide tape 100mm wide.
- Then place your cutting mat on the table and cut the marked strips of fabric with the rotary cutter.
- If your strips are very short, you can still sew them together into one long strip. Place two strip ends right sides together at a 90° angle so that the outer corners overlap by 1 cm. Then stitch the ribbons together with a 1cm seam allowance. Then push the finished strips of fabric into the middle of the wider back of the bias binding maker. Then slide it all the way to the front. To do this, you can use a rounded needle and insert it into the upper slot in the bias tape maker.
- Now the folded bias tape comes out at the front.
- Use the iron to gradually iron the bias tape that is coming out while you continue to pull the bias tape maker backwards. Finally, fold the bias binding in half again and iron over it. Now it's ready to use :)
- You can find the appropriate video instructions here: https://magazin.snaply.de/anleitung-schraegbandformer/
SKU-61724
1
Specific References
New
This battery-operated lint shaver makes woolen clothing look like new in no time. A scissor insert with sharp blades rotates behind the perforated shaving head. When lightly pressed over the fabric, it shaves off protruding lint and small pills and collects them in its collection container. Depending on the material, the distance can be quickly and easily adjusted to two levels. The device can be easily disassembled for cleaning and cleaned with the included brush. Batteries (2 x AA / 1.5 V) are not included.